Filter
Top Products
930490 Rev. A
X. Operating Guide
23
English
X. OPERATING GUIDE
A. CIRCUIT BREAKERS (Figure 1)
1. Notes:
Y
our Guardian Trek has a circuit breaker on the battery case (A).
• In the unlikely event of a short circuit or heavy overload, all power to your scooter
will be shut off.
• To reset your scooter, depress the circuit breaker button located on the front of the
battery case. A few minutes wait is required before the circuit breaker will reset.
2. Repeated Shutdown:
If the scooter continues to shut down after resetting, have it serviced by a supplier.
B. TILLER CONTROL FUNCTIONS (Figure 2)
NOTE– To preserve battery charge, your scooter will go into sleep mode after being left idle 5 minutes.
T
o remove from sleep, turn key off and then back on.
1. Hand Controls
All of the drive controls for the scooter are to be found on the Tiller Control Box.
2. The Pre-Set Speed Knob
Turning the knob to the left reduces your available maximum speed. Turning it to the right
increases the available maximum speed.
3. The Battery Gauge
This gives an approximation of battery charge.
The gauge is marked from “E” empty to “F” full. For extra clarity there is a colored graduat-
ed scale rangiing from RED (Empty) through YELLOW to GREEN (Full).
As the scooter moves over differing terrain, the battery gauge will dip up and down. This is
normal. For a more accurate indication, stop the scooter and note the reading.
GREEN indicates ready for use.
YELLOW indicates batteries to be charged as soon as possible.
RED indicates charge batteries immediately.
NO
TE–
If you fin
d that your battery gaug
e has gone into the red while you are out and about, you can
in
cr
ease th
e r
em
aining range of your scooter by reducing your maximum available speed, but
you MUST charge your scooter as soon as you can.
4. Thr
ottle Lever
The throttle lever offers finger-tip control of your scooter. It controls the speed as well as
forward and reverse motion. Pushing the right-hand side of the lever away from you moves
the scooter forwards. Pushing the left-hand side of the lever away from you moves the
scooter in reverse and sounds a reversing beeper. The more you move the lever the more
your speed increases up to its pre-set maximum. It is possible to operate your scooter
using one side of the throttle lever. To do this you must PUSH and PULL on the chosen side
of the throttle lever.
NO
TE–
On
e-han
d oper
ai
on requires carefull concentration and is more tiring than normal operation.
5. Horn Button
Pressing the yellow horn button operates an audible beep. Use this function to warn pedes-
tri
ans of your presence when necessary.
6. Key On-Off Switch
Make sure that this switch is in the OFF position BEFORE getting on or off the scooter.
Switchin
g this switch to OFF while d
rivin
g will cause th
e scooter to stop very abruptly. This
is not recommended.
1
2
3
5
6
2
4
A