Filter
Top Products
Measurements
1. Turn Power ON
0
When power is turned ON, all display marks appear for approxi-
mately 1 second.
l
When the
"
0
""
is displayed the unit is ready for measurement.
If the
V
until
"
0
:
mark appears, release air with the air release button
appears.
2. Attach the arm cuff to the left arm.
3. Pressurize the arm cuff with the rubber bulb.
l
Pressurize the arm cuff to approximately 30
-
40mmHg above
the estimated Systolic blood pressure to be measured.
0 A buzzer sounds when pressure reaches 160,
200
240 and
280mmHg.
4. When pressurization is completed, the automatic exhaust
mechanism will gradually reduce arm cuff pressure, and the
-
mark wilt appear on the display indicating
that
measure-
ment is in progress.
@Pressure value appears on the left, and exhaust speed on the
right side of the display.
-7
(gradually
being
reduced)
Measurement
Mark
l
Accurate measurement cannot be taken when exhaust speed
is outside the 1
-
5 mmHg range.
l
Remain still during measurement.
@
When a pulse is detected, the pressure value moves to the
right side of the display. At this time the
*,
mark flashes at
9
the same rate as pulse rate, and the buzzer sounds.
. .