Filter
Top Products
ENGLISH
Fitness Scale 7850.02
6
■ Getting started
1. Install the fitness scale level on a firm, flat surface
2. Connect the plug-in power supply unit without
standing on the scale
3. Set the clock and date
Please do not stand on the scale. Keep the
or
key pressed until the display shows the
year. Press the
or key to select the re-
quired year and confirm. Select the month by
pressing the
key and confirm. Select the
day by pressing the
or key and confirm.
The indicator then shows digits for setting the
clock. Adjust the hour by using the
or key
and confirm. Do the same with the minutes and
finally confirm.
4. Insert the thermal
paper roll (58mm
wide) in the paper
compartment (see
figure) and pull out
the paper strip by
several centimetres.
Close the lid and tap
the key “7850”
briefly to test whether the paper feeds through
correctly. The printer has an easy-load function.
There is no need to feed the paper through
manually.
5. The scale is ready to operate
6. To relocate the scale do not pull it,
please lift it up!
■ Mass unit switchover
Slide the switch on the rear at any time to switch
over the mass unit from “kg and cm” to “lb and ft/
inch“ or “st/lb and ft/inch”.
The default setting of the scale is “kg and cm".
The last unit setting is retained even when the
appliance is switched off.
■ Battery exchange:
Please change the lithium battery when time
and date settings are not correct anymore (without
power supply of the scale).
■ Weighing
Stand on the scale as still and straight as possible
while the Fitness Scale measures your weight. After
a short period of time, the weight reading appears
and the “INPUT" message flashes. If you only want
to measure your weight, you can step off the scale
now. The weight reading is printed out. Otherwise
continue as described under Body Analysis.
0.0
kg
0.0 lb
0: 0.0 lb
st
7 2.2
kg