Filter
Top Products
Messages
The scale sets the value
zero automatically when
it is switched on.
The zero range at power-
on is -5% ....+15% of the
weighing range.
If the scale is outside the
set tolerance range, the
display shown adjacent
appears.
Parts weight too small
Zeroing not possible
Taring is not possible
Print not permitted on
over- or underload
Switch to lbs
deactivated
Elimination
Either take the load off
the platform or press the
key to activate the cali-
brated zero point.
There is a mechanical
or electrical fault.
The scale is not suitable
for these parts.
The zero limit has been
exceeded or undershot.
Cannot tare the zero
display or negative values.
Place an object on the
scale / remove an object
from the scale.
Activation is described on
Pages 20/21.
In case of other error mes-
sages, please contact your
SOEHNLE service
Technical data
• Housing made of anodised aluminium
• Operated by means of a tactile keypad.
• Desktop power supply: input 230VAC / 50Hz / 60mA,
output 9VDC / 0.3A
• Charge adapter (optional): input 100-240VAC /
50-60Hz / 0.3 A; output charge current for 4 cells
0.5A, operating voltage 9VDC / 0.3 A
• Operating temperature -10° ..... +40° C
• Storage temperature -20° ..... +60° C
• Zero range -1 %... +3 % of the weighing range (max.)
• Zero range at power-on -5%...+15% of the weighing
range.
• RS 232 (V24) interface for printer or IT connection.
For a description of the interface, please contact your
Soehnle service partner.
77mm
82,6 mm
143,7 mm
306 mm
125 mm
22
ENGLISH