Filter
Top Products
Special dialysis function (intermediate tare)
If this function is set, the operator may give the
patient a blanket or a book or remove them without
affecting the weight reading.
Press the key. "Hold" appears in the display. Give
or take back book and press again. Previous
weight reading will be displayed without Hold but with
"N". The reading is now a net weight. The tare is sto-
red in the tare memory.
Hold function
When this mode is active, press the key. "Hold"
flashes until the value is determined and frozen.
These 6 modes are settable in User mode:
BMI classification (as per DGE - German Society for Nutrition, Nutrition Report 1992)
Classification
Underweight < 20 < 19
Normal weight 20 - 25 19 -24
Overweight 25 - 30 24 -30
Adiposity 30 - 40 30 - 40
Severe adiposity > 40 > 40
19
ENGLISH
Extended functions
The key can be programmed with the following
functions: Hold, unit switch-over, BMI and special
Dialysis function. The standard function programmed
is BMI. You can make changes in User mode
(p. 20/21).
• Press the function key .
• Display, e.g. 170 = body height in cm
• Body height > 170cm: Press key until body
height is correct.
• Body height < 170cm: Press key until body
height is correct.
• Confirm by pressing .
• Display switches to weighing mode 0.00 kg.
• Weighing.
• After the scales have stopped moving, the display
shows the BMI and weight alternately.
Mode Hold Remove by pressing
Manual
At a standstill outside
the zero range
key
Automatic Remove load from scale
Slave pointer,
manual
For weight increase
and repeated standstill
key
Slave pointer,
automatic
Remove load from scale
Maximum value,
manual
of the maximum
weight reached
(without being at a standstill)
key
Maximum value,
automatic
Remove load from scale