Shoprider Scootie Mobility Aid User Manual


 
9/22/2004
14
MAINTENANCE
Lubrication
At six-month intervals you should lubricate the following parts with a light oil or similar lubricant:
Seat pivot post.
Seat release lever pinion.
Wheel bearings.
Axle of scooter.
CAUTION – DO NOT USE WD40 TO LUBRICATE PARTS!! DO NOT LUBRICATE
TRANSAXLE/GEAR BOX!! In the event of any difficulties please consult your dealer.
Wheels and Tires
The wheels of your scooter might have split rims (except for the XtraLite 3 where the rim and tire
are one molded piece together). To change the wheels remove the center bolt and slide the wheel off
its axle. Ensure that when refitting the wheel the retaining bolt is fitted with a locking washer or the
screw threads are treated with lock-tite or a similar adhesive.
TROUBLE SHOOTING GUIDE
Circuit Breaker
Your scooter is fitted with the latest in electronic controls that are programmed to protect the
electrical system from abnormal overloads. Provided for extra protection is a circuit breaker.
Should there be a situation where your scooter stops for no apparent reason, please check that the
circuit breaker has not popped. ON THE SCOOTIE AND SUNRUNNER S the circuit breaker can
be found under the rear chassis cover accessible through a port hole under the seat and can be reset
by pressing the black button. ON THE XTRALITE 3 AND XTRALITE 4 the circuit breaker is
located on the side of the battery pack.
Check List
If your scooter fails to operate, please check the following:
Unit is switched on.
All plugs and connectors are clean and firmly connected.
Battery level shows full charge.
Freewheeling device is in the drive position.
If the free wheel device has been operated with the scooter switched on, then the scooter will not
operate until the ignition key has been switched off and then on again.
Please consult your dealer if your scooter does not run after checking these points.