Shoprider Scootie Mobility Aid User Manual


 
9/22/2004
13
Dismantling
1. Remove baskets.
2. Fold down the back of the seat.
3. For Sunrunner S: pull up on the red lever under the seat and at the same time lift and twist the
seat off.
For XtraLite 3; XtraLite 4; Scootie: unscrew the tightening bolt below the seat. Lift seat off.
For XtraLite 3 & XtraLite 4 ONLY.
1. Lower tiller toward the foot rest and connect the carrying rod (For XtraLite 3) to the proper
location or connect the two Velcro straps (For XtraLite 4) to the handle bars.
For Scootie & Sunrunner S ONLY.
2. Remove the rear chassis cover/battery pack.
3. Remove the locking pin and separate the rear drive unit (Fig. 11).
4. Lower the tiller to its lowest level on the front chassis and connect the carrying rod (if the rear
drive unit is NOT separated).
BATTERIES AND BATTERY CHARGER
The Shoprider® scooter is supplied with maintenance free, sealed lead acid batteries. Battery
performance can be affected by temperature, terrain, condition of battery, the weight of the user, etc.
The battery level indicator is only a guide and is most effective when the scooter is moving, only
then is the true discharge level displayed.
When the scooter stops the battery level indicator may indicate full.
An active user can use up to 30% of battery capacity or more per day.
Inactive users may only use 50% of battery capacity in a week.
In both these instances the battery should be put on charge over night.
Battery Charger
Batteries supplied with your scooter are specially designed. All units require an automatic battery
charger. XtraLite 3 and XtraLite 4 have built in charger ports on the side of the battery pack.
The battery chargers are 2-amp transformer type off board.
Charging
To charge the batteries connect the plug lead into the battery-charging socket on the scooter/battery
pack and the 2 or 3-prong plug into the wall socket and switch on. FOR Scootie and Sunrunner S
ONLY: the battery charger has two lights. The red light when constant shows the battery charger is
connected if the red light flashes; there is a break in the connection. A steady green light will show
the unit is charging. When the light turns solid red again while still plugged into the charging port
the unit is fully charged. DO NOT OVER CHARGE THE UNIT.
FOR XTRALITE 3 & 4: Connect 3 prong round plug to their charging port, located on the side of
the battery pack. The charger will show a solid green light when plugged in the all. Once plugged
into the charging port a steady red light will indicate that the unit is charging. When the red light
turns green while still connected to the charging port, the unit is fully charged. DO NOT OVER
CHARGE THE UNIT.
CAUTION: Always ensure that the charging lead is in good condition and has not been damaged
or stretched.