Shoprider GR889 Mobility Aid User Manual


 
12/2/2004 - 8 -
SCOOTER TILLER CONTROLS (FIG 4)
Speed Controls
The speed control allows you to set
a speed between 1 (minimum) and
10 (maximum).
Battery Level Indicator
The number of red bars shows the
amount of charge left in your
batteries. The amount of charge
will only show at its true level when
the scooter is in drive.
Caution – Do not allow the
battery level indicator to go
down completely as complete
discharge of the batteries could
cause irreversible damage.
Horn
A yellow button at the rear of the tiller operates the horn.
Hand Lever Controls
The right hand lever controls the forward motion and the left hand lever controls the reverse
motion. The amount of pressure applied to each lever will determine the speed the scooter
travels, up to the speed designated with the speed dial. Release the lever and the scooter
will automatically come to a stop as the electromagnetic brake is applied to the motor.
On/Off Key Switch
Insert the key in the right side of the tiller. Turn the key and the battery light indicator will
light up. There may be a slight delay before the hand lever control can be operated, while
the controller checks the circuits.
Electromagnetic Brake
The brake is automatically operated when the control levers are pressed or released.
There is a slight delay when the scooter decelerates; this allows the scooter to come to a
smooth stop.
Figure 4
Li
g
ht
Key Switch
Finger Lever
Control
Speed
Co
ntr
o
l
Horn
Battery Level
In
d
i
ca
t
or