5/11/2004
9
SCOOTER TILLER CONTROLS (FIG. 11A&B)
Speed Controls
The speed control allows you to set a speed between 1 (minimum) and 10 (maximum).
Battery Level Indicator
The number of LED bars lit, shows the amount of charge left in your batteries. The amount of
charge will only show at its true level when the scooter is in drive.
Caution – Do not allow the LED bars go out completely as complete discharge of the batteries
could cause irreversible damage.
Lights
A blue colored button at the rear of the tiller operates the lights.
Horn
A yellow button at the rear of the tiller operates the horn.
Thumb/Finger Lever Controls
The left thumb/finger lever controls the reverse and the right thumb/finger lever controls the
forward motion. The amount of pressure applied to each lever will determine the speed the
scooter travels at. Release the lever and the scooter will slowly come to a stop and the
electromagnetic brake will be applied.
On/Off Key Switch
Insert the key in the right side of the tiller. Turn the key and the LED bars will light up. There is
a delay before the thumb/finger lever control can be operated, while the controller is checking
the circuits.
Indicator Switch
Operates turn indicator lights.
Hazard Warning Switch
A red button operates all indicator flashers.
Figure 11B
Lights
Finger
Lever
Control
Key
Switch
Hazard
Lights
Battery Level Indicator
Indicator
Switch
Speed
Controls
Figure 11A
Battery Level
Indicato
r
Horn
Key Switch
Thumb Lever
Control
Li
g
h
t
Speed
Controls