Filter
Top Products
6
9 • Cleaning the soleplate
In normal use a draggy coating may build up
on the soleplate (starch, detergent buildup,
burnt synthetic fibers). This can be easily
removed by using the Rowenta Soleplate
Cleaning Kit or a quality hot iron soleplate
cleaner available at most stores.
To prevent scratching of the soleplate, do not
iron over sharp objects (zippers, etc.). Do not
place the iron on rough surfaces, e.g. metal
iron support, which may scratch the soleplate.
Place the iron on its rest on top of the base of
the unit.
Always put the iron with the soleplate down on
the iron rest, never place on its heel.
10 • Rinsing out the
boiler
To ensure optimum steam performance, the
boiler must be rinsed out after every 10 uses. If
your tap water is hard increase the frequency.
Check that the generator is unplugged and
cold.
Fill the boiler 3/4 full with tap water.
Shake the boiler for a few moments and then
empty it over a sink (D).
Repeat the process.
Wipe the generator base regularly with a damp
cloth and wipe dry.
Boiler Cap
To ensure a proper seal, please check the red
rubber ring in the safety cap for wear and
tear regularly. If wear is noted, replace ring.
Replacement rings are available through our
main service centers.
MAINTENANCE AND CLEANING
Before cleaning ensure that the appliance is unplugged and completely cooled down.
The iron can be cleaned with a damp cloth and wiped dry. Never use household cleaners,
descalers or solvents.
8 • After ironing
Turn the unit off. (Consult section “Turning On
and Off”).
Unplug the appliance.
Place the iron on the iron rest and allow to cool
completely which will take approximately 1
hour.
Once cold, empty water from the appliance
before storing. We recommend emptying the
boiler when not in use.
Do not use descaling agents.
Never hold the generator under the tap.
Notice Pressure iron & steamer 24/08/06 10:14 Page 6