Filter
Top Products
5
4 • Steam ironing
The appliance allows steam output to be
adjusted.
• setting on the iron : the steam control dial
should be set to min.
•• setting on the iron : the steam control should
be set at the mid level.
••• setting on the iron : the steam control dial
can be set to the max.
5 • Dry ironing
This appliance can be used for dry ironing if
the steam button is not pressed.
Set the iron’s on/off switch to the on position.
Do not turn on the steam switch.
6 • Vertical steam
To remove wrinkles in cotton or linen, the
soleplate can come into contact with the fabric
for optimal results.
For synthetic fabrics, a distance of 4 inches is
recommended to avoid damage to the
garment.
For delicate fabrics, we recommend carrying
out a test on an unobtrusive part of the
garment (inner seam).
Fill iron according to the “Filling the boiler”
section of instructions.
Press on/off switch (B), the iron light and
steam indicator light will turn on.
When the steam indicator light turns off
(approximately 7 minutes), steam is ready.
Hang the garment on a coat hanger and hold
the fabric from the bottom of the garment
slightly taut with one hand.
Holding the iron in a vertical position, press
continuously on the steam button while
moving the iron from the top of the garment to
the bottom (C).
7 • Filling the boiler while in
use
Before opening the boiler, ensure that there is
no steam inside. To do this, press the steam
button and keep it pressed until there is no
more steam.
Turn the unit off (see section “Turning On and
Off”) and unplug from outlet.
Slowly unscrew the boiler cap. Using a water
pitcher, fill with 33 oz. of water. Do not fill water
tank past the base of the boiler cap thread. Be
sure that water does not spill over. If this
occurs remove the excess water.
Replace the boiler cap and screw it on tightly.
Plug back in to electrical outlet.
TYPE OF FABRIC
IRONTHERMO-
STAT SETTING
STEAM CONTROL
DIAL SETTING
LINEN, COTTON
•••
WOOL, SILK
••
SYNTHETIC
(Viscose, Polyester)
•
Note : It is normal for the connection cord to
become warm during use.
Caution : Steam produced is very hot. To
avoid burns and scalding never iron or
steam clothes while they are being worn.
Before using the generator for the first time
or if you have not used the steam function
for a few minutes, press the steam button
several times in a row while holding the iron
away from your clothes. This will enable any
cold water to be removed from the steam
connection cord.
When ironing start with fabrics that require a
low temperature setting (•) and finish with
those which need the highest temperature
(•••).
Mixed fiber fabrics should be ironed on the
temperature for the most delicate fabric. For
example a shirt that is 60% cotton and 40%
polyester should be ironed at the (•) setting
for synthetics.
If spray starch is used, spray it onto the
reverse side of the garment. Allow starch to
penetrate before ironing.
For best results, use a mesh type ironing
board to allow excess steam to escape.
For delicate fabrics, we recommend carrying
out a test on an unobtrusive area of the
garment such as an inner seam.
Caution : Never unscrew the boiler cap while
iron is producing steam and boiler is under
pressure.
Never iron or steam clothes while they are
being worn.
Notice Pressure iron & steamer 24/08/06 10:14 Page 5