Filter
Top Products
10.3 Inspection
Check each push handle for evidence of bending.
Check each push handle for evidence of cracking through nutsert holes.
Check handgrip is secure.
Check for free movement of plunger. Lubricate with light oil.
Check that plunger locates in the hole at rear of the side frame.
Ensure nyloc nut still grips thread.
10.4 Push Handle Removal
Unscrew 4 off 2BA countersunk screws holding the seatback upholstery to the Push Handle Assembly.
Unscrew M6 nut and withdraw the bolt.
10.5 Push Handle Fitting
Insert 1/4 UNF bolt through Push Handle and hinge bush. Tighten the nyloc nut until Push Handle
pivots freely without excessive free-play.
Fit 4 off No 10 UNF countersunk screws to hold the seatback upholstery to the Push Handle Assembly.
Wrap the 50mm wide Velcro strap around the lower end of the Push Handle and secure to the rear.
Section 10 Page 2 of 2