Remington R-9200 Electric Shaver User Manual


 
Charging
Prior to using your shaver for the first time, put it on
charge for 24 hours.
To charge your shaver:
Make sure your shaver is turned off.
Connect the cord to the shaver and then the charging
adapter to the electric outlet. A charging indicator light
will come on.
Your shaver cannot be overcharged, so you can leave
it plugged in and charging between shaves.
Use only the charging adapter supplied with the
shaver.
The R-9100/-9200/-9300/-9250/-9350/R-TCT come
with a special feature that allows you to run the shaver
directly off the cord. Your shaver will not recharge while
you are shaving, so after shaving directly from the cord,
turn the unit off and set aside to charge.
The R-9100/-9200/-9300/-9250/-9350/R-TCT will
provide up to two weeks worth of shaving after a one
hour charge or a single shave after five
minutes of charging.
Model R-9100
has a green indicator light to show whether the shaver
is either fully charged or charging. A red low-battery
indicator illuminates to show when the shaver needs
r e c h a r gi n g .This also indicates ap p r o x i m at e ly 5 minutes
of shaving time left when indicator first comes on.
Model R-9200/-9250
features a green lighted fuel gauge that displays the
amount of charge remaining in 20% increments. When
only 20% of the charge remains,the recharge red
warning light illuminates.
Model R-9300/-9350/R-TCT
has an LCD display numeric indicator to show shaver
charge status in minutes remaining. When the Plug icon
comes on,it indicates approximately 5 to 6 min-
utes of shaving time left.
Troubleshooting:
If your R-9100/-9200/-9300/-9250/-9350/R-TCT shaver bat-
tery is completely discharged or the shaver has not been used for
an extended period of time, the shaver may not start when operat-
ed using the cord. If this condition occurs, charge the shaver fo r
ap p r o x i m at e ly five minutes before shaving.
Your R-9100/-9200/-9300/-9250/-9350/R-TCT c o r d / c o r d l e s s
s h a ver should not be used strictly as a cord-operated shaver, as
continued cord only use will result in reduction of battery life.
In order to preserve the life of the batteries, they should be fully
discharged every six months and then fully charged for 24 hours.
World Wide Voltage (all MicroFlex
®
TCT
models)
You can take your shaver with you when you travel to just about
anywhere in the world. Your MicroFlex
®
TCT
shaver features
worldwide automatic dual voltage conversion providing AC current
between 100-240 volts AC, 50-60 Hz. Just plug it in to the local
outlet (you may need an adapter plug) and use as usual.
Your shaver will convert automat i c a l ly to the local current
requirements.
Battery Removal:
When your rechargeable shaver reaches the end of its useful life,
the batteries must be removed from the shaver and be recycled
or disposed of properly in accordance with your state and local
requirements.
THE FOLLOWING PROCEDURE SHOULD BE FOLLOWED
FOR BATTERY REMOVAL:
To avoid a possible electric shock hazard,unplug cord from elec-
tric outlet and shaver.
Open the head assembly by pressing the
head release buttons and lifting the head
assembly. Pull the entire head assembly off of
the shaver assembly.
Push the trimmer button up to open the
trimmer.
Remove the trimmer assembly by squeezing
the sides as shown in the picture.
Using a small Phillips head screwdriver,
remove the 3 screws from the back of the
s h av e r.
Pull or gently pry the shaver halves apart,
exposing the battery.
Pry the lower battery clip off.
Lift or pry the batteries out of the shaver.
Cut the wires on both ends of each battery and
remove them from the shaver.
CAUTION:DO NOT PUT IN FIRE OR MUTILATE
YOUR BATTERIES WHEN DISPOSING AS THEY M AY
BURST OR RELEASE TOXIC MAT E R I A L S .DO NOT SHORT CIRCUIT AS IT
MAY CAUSE BURNS. DISPOSE PROPERLY
IN ACCORDANCE WITH YOUR LOCAL AND STATE REQUIREMENTS.
The EPA certified RBRC
®
Battery Recycling Seal on the nickel-
cadmium (Ni-Cd) battery indicates Remington Products Company,
L.L.C.is voluntarily participating in an industry program to collect
and recycle these batteries at the end of their useful life, when taken
out of service in the United States or Canada. The RBRC
®
program
provides a convenient alternative to placing used Ni-Cd b atteries
into the trash or the municipal waste stream, which
may be illegal in your area. Please call 1-800-8-BAT T E RY
for
i n fo r m ation on Ni-Cd bat t e ry recycling and disposal bans/restriction
in your area. Remington Products Company, L.L.C.’s involvement
in this program is part of our commitment to preserving our
e n v ironment and conserving our natural resources.