Filter
Top Products
Cleaning your shaver:
TO ASSURE OPTIMAL PERFORMANCE, IT IS RECOM-
MENDED T H AT YOU CLEAN YOUR SHAVER AFTER EACH
USE. The cutting system of this shaver was designed t o
be cleaned by rinsing under warm running water or by
b r u s h i n g .
Cleaning your Remington
®
MicroFlex
®
TCT™ Shaver is
easy. (NOTE: With the R-9300/-9350/R-TCT model, the brush
icon will blink to remind you to clean your shaver.)
■ Open the hairpocket by squeezing
on both buttons and rotating away
from the body of the shaver. You may
blow out the stubble thoroughly, or
rinse the shaver head in water. Rinse
both sides of the head assembly.
■ At Least Once a Week:
For more complete cleaning, remove the cutter retainer
assembly from the hairpocket by turning the center knob
approximately 1/4 turn counter clock-
wise. Hold cutter retainer assembly as
shown, and remove head by turning
approximately 1/8 turn in the direction
shown. Brush clean both the head and
the cutter. Reassemble head to cutter
retainer assembly by aligning and turn-
ing head 1/8 turn in the opposite direction. Repeat this
process for each of the 3 heads. Clean each head and
cutter set one at a time to prevent mixing cutter compo-
nents.(These should be kept as sets). After cleaning,
place cutter retainer assembly in the hairpocket,and
secure by turning center knob
approximately 1/4 turn clockwise.
Caution: Never put the shaver
completely under water.
Do not use any aggressive
cleansing agent as this may
destroy the shaver coatings.
■ To clean and lubricate your shaver’s cutters and head assembly,
apply Remington
®
Shaver Saver
®
(SP-4) Lubricant. The lubricant
helps remove hair clippings while reducing wear.A quick spray after
each shave keeps your shaver operating at peak performance.
Caution: Do not remove or replace the head assembly while
shaver is running or plugged into an electrical outlet as it may
cause damage to the unit’s cutters.
■ Worn or damaged parts should be replaced with Remington
®
replacement parts only.
When is it time to replace our heads
and cutters?
It is very important to replace your heads and cutters
when necessary to insure a close, comfortable shave
without irritation. We recommend they be replaced
every 12 months. Here are some signs of head and
cutter wear, indicating that replacement is needed.
(NOTE:R-9300/-9350/R-TCT cutter icon,R-9200 &
R-9250- the yellow LED- will blink when it is time to
replace the cutters.)
Irritation:
As the heads get excessively worn there may be some
skin irritation. This would be especially noticed when
applying After Shave lotion.
When the cutters wear you may feel a sense of
“pulling”and a loss of closeness when you shave.
This is an indication that it is time to replace your
heads and cutters.
H a i r p o c k e t
Head
Cutter