Filter
Top Products
Removing the Headguard
Before operating your shaver, remove the headguard,
which protects the screen and cutter assembly. It is
important to remove the headguard correctly to avoid
damaging the clips that hold it firmly to the shaver.
■ Press lightly on the top of the
head guard.
■ Lift the lower rear edge.
■ Pull the headguard aw ay from
the shaver.
Shaver Operation
Your shaver has a toggle power button that has diff e r e n t
o p e r a ting characteristics depending on which model
shaver you have.
Models MS3-1700 & MS3-2700:
Lower side:ON; Upper side:OFF
Models MS3-3700 & MS3-4700:
Lower side:ON/OFF; Upper side:
Activates and deactivates the high-
speed Turbo setting.
Trimmer Operation
Your MicroScreen
®
shaver is equipped with a 3-position
trimmer.
Position 1: Retracted and out of the way.
Position 2: Long hair intercept with floating action.
(Deployed by pressing LEFT side of trimmer button)
Position 3: Sideburn / Mustache Trimmer
(Deployed by pressing RIGHT side of trimmer button)
The Trimmer can be manually retracted to setting 1
from either setting 2 or setting 3, by pressing down
on the trimmer.
Charging
Prior to using your shaver for the first time, put it on charge fo r
24 hours.
To charge your shaver:
■ Make sure your shaver is turned off.
■ Connect the cord to the shaver and then the charging adapter
to the electric outlet.A charging indicator light will come on.
■Your shaver cannot be overcharged,so you can leave it plugged
in and charging between shaves.
■ Use only the charging adapter supplied with the shaver.
■The MS3-1700 is designed for cordless operation only.Plugging
in the cord will not provide the power to shave.The MS3-2700/
3700/4700 on the other hand,come with a special feature that
allows you to run the shaver directly off the cord. Your shaver will
not recharge while you are shaving,so after shaving directly from
the cord,turn the unit off and set aside to charge.
■ The MS3-2700/3700/4700 will provide up to two weeks worth
of shaving after a one hour charge or a single shave after five
minutes of charging.
Model MS3-1700
The green light indicates that the shaver is chargi n g . Full charge
is achieved in 16 hours.
Model MS3-2700
A green indicator light shows whether the shaver is either fully
charged or charging.A red low-battery indicator illuminates to show
when the shaver needs rechargi n g .This also indicates ap p r o x i m at e ly
5 minutes of shaving time left when indicator first comes on.
Model MS3-3700
A green lighted fuel gauge displays the amount of charge remaining
in 20% increments.When only 20% of the charge remains,the
recharge red warning light illuminates.
Model MS3-4700
An LCD display numeric indicator shows shaver charge status i n
minutes remaining. When the Plug icon comes on, it
i n d i c ates ap p r o x i m at e ly 5 t0 6 minutes of shaving time left.
Troubleshooting:
■ If your MS3-2700/3700/4700 shaver battery is completely
discharged or the shaver has not been used for an extended
period of time,the shaver may not start when operated using
the cord.If this condition occurs, charge the shaver for
ap p r o x i m at e l y five minutes before shaving.
■ Your MS3-2700/3700/4700 cord/cordless shaver should not
be used strictly as a cord-operated shaver,as continued cord
only use will result in reduction of battery life.
■ In order to preserve the life of the batteries,they should be fully
discharged every six months and then fully charged for 24 hours.
Worldwide Voltage (MS3-2700/3700/4700 ONLY)
You can take your MS3-2700/3700/4700 shaver with you when you
travel to just about anywhere in the world.Yourshaver features
worldwide automatic dual voltage conversion providing AC current
between 100-240 volts AC,50-60 Hz.Just plug it in to the local
outlet (you may need an adapter plug) and use as usual. Yo u r
s h aver will convert automat i c a l ly to the local current requirements,
if any.
The MS3-1700 model is a single voltage model (120 VAC,60 Hz).
Battery Removal:
When your rechargeable shaver reaches the end of its useful life,
the batteries may be removed from the shaver and be recycled
or disposed of properly in accordance with your state and local
requirements,if any.If this is not required by law, you may elect to
dispose of the shaver without removing the batteries.
CAUTION: DO NOT PUT IN FIRE OR MUTILATE YOUR BATTERIES
WHEN DISPOSING AS THEY M AY BURST OR RELEASE T OXIC MAT E-
R I A L S . DO NOT SHORT CIRCUIT AS IT MAY CAUSE BURNS.DIS-
POSE PROPERLY IN ACCORDANCE WITH YOUR LOCAL AND STATE
REQUIREMENTS FOR NICKEL-METAL HYDRIDE BATTERIES.