Filter
Top Products
BEFORE YOU BEGIN
2
WARNING:
DO NOT USE NON-RAZOR
PARTS WITH YOUR RAZOR
ELECTRIC SCOOTER. The
scooter has been built to certain
Razor design specifications. The
original equipment supplied at the
time of sale was selected on the
basis of its compatibility with the
frame, fork and all other parts.
Certain aftermarket parts may or
may not be compatible and will
void your warranty.
Required Tools
Remove contents from box. Remove the foam separators that protect the components from damage during
shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have
occurred during shipping. Because the scooter is 95 percent assembled and packed at the factory, there
should not be any problems, even if the box has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY ASSEMBLY
OR MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Allow up to 10 minutes for assembly, not including initial charge time.
Allow up to 12 hours for initial charge (see page 5 for charging information)
Charger
Plug
Charger
Port End
3. Charger
(Note: Charger design
may vary from one shown)
Need Help? Visit our website for replacement parts, product support and a list of authorized service centers
at www.razor.com or call toll free 866-467-2967 Monday - Friday 8AM - 5PM Pacific Time. Please have the
product I.D. code (located on the white label on your product or back of charger) available for better assistance.
1. Handlebar
Stem
2. Battery Tray
Twist Grip Throttle
PRODUCT I.D. CODE
1. Handlebar Stem
2. Battery Tray
3. Charger
4. UPC Side of Box (not shown)
5 mm Allen Wrench (Included)
Two (2) 4 mm Allen Wrenches
(Only Included with E300S)
8 mm/10 mm/16 mm
Wrenches (Not Included)
Phillips Screwdriver
(Only Included
with E300S)
Valve Extender
(Located in right
handlebar grip)
Bicycle-style tire pump
for Schrader valve tires
with pressure gauge
(Not Included)