Razor E125 Mobility Scooter User Manual


 
5
q Chain and Rear Wheel Replacement
Tools required: Phillips screwdriver and two (2) 13 mm open wrenches.
1 With a Phillips screwdriver,
loosen the two screws and
remove the chain guard.
2 Using two 13 mm open
wrenches, loosen the locknuts
by turning the wrenches counter
clockwise. Reference rear wheel
hardware sequence (page 6).
3 To loosen the chain, pushing
the tensioner down to create
some slack in the chain.
1 Using a 10 mm open wrench
loosen the brake cable bolt.
q Front Wheel Replacement
Tools required: 10 mm open wrench and two (2) 16 mm open wrenches.
2 Using two 16 mm open
wrenches, loosen the locknuts
by turning the wrenches counter
clockwise. Remove wheel and
install replacement wheel.
Reference front wheel hardware
sequence on this page.
Right Side (Throttle)
8-3 Spacer
8-2 Washer
Fork
8-2 Washer
8-7 Spring Washer
8-1 16 mm locknut
Left Side (Brake)
8-5 Spacer
8-2 Washer
Fork
8-2 Washer
8-7 Spring Washer
8-1 16 mm locknut
Middle
8-6 Front axle bolt
Note: Front wheel hardware
sequence
REPAIR AND MAINTENANCE
Turn power switch “OFF” before conducting any maintenance procedures.
1 To adjust brake cable play,
thread the brake lever adjuster in or
out 1/4 to 1/2 turn until the desired
brake adjustment is attained. Most
adjustments are complete at this
step. If brake still needs further
adjustment, proceed to step 2.
2 If brake is too tight or has too
much slack, use a 10 mm open
wrench to loosen the brake cable
and adjust accordingly.
3 Inspect the brake pads (A)
for proper alignment against
the wheel or excess wear. To
realign brake pads, loosen the
fixing nut (B) and adjust the pad
to contact the rim. Retighten
and readjust as needed. Verify
proper brake function prior to
riding the scooter.
q Adjusting the Brakes
Tools required: 10 mm open wrench
8-2
8-1
8-2
E1XX US VERSION
--- wheel hardware sequence
Front wheel hardware sequence
Rear wheel hardware sequence
8-1
8-2
8-5
8-6
8-3
8-2
8-7
8-7
3 Reassemble, adjust and
tighten brake cable. Verify
proper brake function prior to
riding the scooter.