Filter
Top Products
2
Underneath
Battery Tray
Twist Grip Throttle
Remove contents from box. Remove the foam separators that protect the components from damage during
shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have
occurred during shipping. Because the scooter was 95 percent assembled and packed at the factory, there
should not be any problems, even if the box has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY ASSEMBLY
OR MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult with experience in bicycle mechanics.
Allow up to 10 minutes for assembly, not including initial charge time.
Allow up to 12 hours for charge (see page 3 for charging information)
BEFORE YOU BEGIN
WARNING:
DO NOT USE NON-
RAZOR PARTS WITH
YOUR RAZOR ELECTRIC
SCOOTER.
The scooter has been built
to certain Razor design
specifications. The original
equipment supplied at the time
of sale was selected on the basis
of its compatibility with the
frame, fork and all other parts.
Certain aftermarket parts may
not be compatible and will void
the warranty.
Required Tools
Need Help? Visit our website for replacement parts, product support and a list of authorized service centers
at www.razor.com or call toll free 866-467-2967 Monday - Friday 8AM - 5PM Pacific Time. Please have the
product I.D. code located on the white label on your product or back of charger available for better assistance.
3. Charger
(Note: Charger design may
vary from one shown)
Note: Electric scooter must
be moving at 3 mph/4.8 kph
while applying the throttle
to engage motor.
Product ID Locations:
See locations to the left
1. Handlebar Stem
2. Underneath Battery Tray
3. Charger
4. Box - Side of UPC (not shown)
Schrader-type
3 mm
Phillips
Charger
Plug
Charger
Port
1.
2.