Filter
Top Products
30 www.pridemobility.com Q6 Edge HD
To adjust the positioning belt for operator comfort:
1. Once seated, insert the metal tab on one side of the belt into the plastic housing on the opposite side until you
hear a click. See figure 20.
2. Pull the excess strap attached to the metal tab until it is secure, but not so tight as to cause discomfort.
To release the positioning belt:
1. Press the push button mechanism on the plastic housing.
MANDATORY! Make sure the positioning belt is properly secured to the power chair and is
adjusted for operator comfort before each use.
MANDATORY! Inspect the positioning belt for loose or damaged parts before each use of the
power chair. If you discover a problem, contact your Quantum Rehab Provider for maintenance
and repair.
Positioning Belt
Your power chair may be equipped with a positioning
belt that can be adjusted for operator comfort. See fig-
ure 20. The positioning belt is designed to support the
operator so that he/she does not slide down or forward
in the seat. The positioning belt is not designed for use
as a restraining device.
WARNING! The positioning belt is not
designed for use as a seat belt in a
motor vehicle. Nor is your power chair
suitable for use as a seat in any
vehicle. Anyone traveling in a vehicle
should be properly belted into seats
approved by the vehicle manufacturer.
WARNING! The positioning belt should
be secured at all times. Never allow
the positioning belt to hang or drag on
the floor as it may become entangled.
To install the positioning belt:
1. Remove the rearmost screw that holds the seat
hinge to the seat base on both the left and right seat
hinges.
2. Insert the screw through the supplied washer,
through the positioning belt and into the seat base
for each side of the power chair seat.
3. Tighten both screws.
V. COMFORT ADJUSTMENTS
Figure 20. Positioning Belt Adjustment