Filter
Top Products
Q6 Edge HD www.pridemobility.com 23
IV. ASSEMBLY
Figure 13. Transit Securement Brackets
Figure 12. Controller Harness Routing on a Contour
Seat
WIRE TIES
TO POWER BASE
Power Chair Securement Points
This power chair may be equipped with four (4) tie-
down points for the purpose of securing the unoccu-
pied power chair during motor vehicle transport. Each
tie-down point is clearly labeled for this purpose.
To secure a power chair equipped with tie-down
points:
Always secure the power chair in a forward-facing
position in the vehicle.
Attach the four tie-down straps only to designated,
labeled transit securement points indicated by
anchor symbols on the power chair. See figure 13.
Tighten the straps to sufficiently remove all the
slack.
Never attach tie-downs to adjustable, moving, or
removable parts of the power chair such as arm-
rests, front riggings, and wheels.
Position the anchor points for the rear tie-down
straps directly behind the rear securement points on
the power chair. The front tie-down straps should
be anchored to floor points that are spaced wider
than the power chair to provide increased stability.
See figure 14.
MANDATORY! The power chair should
be used as indicated in the
manufacturer’s instructions. If you
have any questions about the proper
use of your power chair, contact your
Quantum Rehab Provider.
SECUREMENT BRACKETS
SECUREMENT BRACKETS