Filter
Top Products
Quantum Q4 www.pridemobility.com 19
Controller Position
You can move the controller in toward or out away from the
armrest, or change the position of the controller for either left-
hand or right-hand use.
MANDATORY! Prevent controller harness
damage! Avoid routing the controller harness
on the outside of the armrest pad. Route the
harness under the armrest or toward the inside
of the armrest pad. Use correct tie-down
points for the controller harness to prevent the
harness from getting caught in the drive tires,
pinched in the seat frame, or damaged when
passing through doorways.
To change the controller position:
1. Turn off the power to the controller.
2. Unplug the controller connector from the front of the power
base. See figure 3.
3. Remove any wire ties securing the controller harness to the
armrest.
4. Loosen the adjustment knob on the armrest where the
controller is currently located. See figure 18.
5. Relocate the controller to the desired armrest and tighten
the adjustment knob to secure the controller.
6. Use wire ties to secure the controller harness to the armrest.
7. Route the controller harness to the front of the power base
and reconnect the controller. See figure 19.
NOTE: If your power chair is equipped with a Synergy Seat
or TRU-Balance Power Positioning System, refer to the infor-
mation provided in supplemental manuals provided with your
seating system.
V. COMFORT ADJUSTMENTS
Figure 18. Controller Position
Figure 19. Cable Routing