Filter
Top Products
Quantum Q4 www.pridemobility.com 13
DETENT PIN
Seat Installation
It may be necessary to install the seat either prior to
initial operation or after transporting your power chair.
NOTE: If your power chair is equipped with a Syn-
ergy Seat or a TRU-Balance Power Positioning Sys-
tem, refer to the information provided in separate
manuals.
WARNING! Do not pick up the seat
frame by the armrests. They are free to
pivot, and you may lose control of the
seat if they do so.
To install the seat:
1. Tilt the seat back and align the interfaces on the
bottom rear of the seat with the rear seat secure-
ment brackets on the power base and secure with
the hardware. See figure 7.
2. Pivot the seat down and secure the front seat inter-
face into the top of the actuator with the detent pin.
WARNING! Make sure the hardware
and detent pin are properly secured
before using your power chair.
3. Install the controller and route the harness to the
back of the power base. See figure 6.
MANDATORY! Prevent controller
harness damage! Avoid routing the
controller harness on the outside of
the armrest pad. Route the harness
under the armrest or toward the inside
of the armrest pad. Use correct tie-
down points for controller harness to
prevent the harness from getting
caught in the drive tires, pinched in the
seat frame, or damaged when passing
through doorways.
4. Plug the controller connector into the rear of the
power base. See figure 3.
5. Secure the controller harness to the armrest
receiver with wire ties. See figure 8.
IV. ASSEMBLY
Figure 7. Mounting System and Contour Seat
INTERFACE
ON BOTTOM
REAR OF
SEAT
TOP OF THE
ACTUATOR
REAR SEAT
SECUREMENT
BRACKET
Figure 8. Controller Harness Routing on a Synergy Seat
FRONT SEAT
INTERFACE