Filter
Top Products
30 www.quantumrehab.com Quantum 610 Series
V. COMFORT ADJUSTMENTS
Power Elevating Seat (Optional)
If your power chair is equipped with a power elevating seat, you
can change the seat height either through the controller or through
a toggle switch mounted to one of the armrests.
To change the seat height through toggle switch:
1. Press forward on the toggle switch to raise the seat. See
figure 24.
2. Pull back on the toggle switch to lower the seat.
WARNING! Do not allow the motor to run more than a few seconds after the mechanism reaches
the top or bottom limit.
NOTE: For more information on operating the power elevating seat through the controller, contact your
Quantum Rehab Specialist.
WARNING! The power elevating seat option is intended for use on a level surface only. Never
raise the seat from its lowest position on an inclined surface. Failure to heed this warning can
result in the power chair tipping over.
WARNING! Never raise the seat from its lowest position when operating your power chair on
bumpy or uneven surfaces. Failure to heed this warning can result in the power chair tipping
over.
WARNING! Never raise the power elevating seat while your power chair is in the freewheel mode.
WARNING! Always fasten the positioning belt when operating the power elevating seat.
NOTE: The power elevating seat option is equipped with a system that reduces the speed of the power chair by
one half when the seat is elevated more than 1–2 inches (2.54-5.08 cm). Always check to be sure this system is
operating properly before using your power chair.
Figure 24. Power Seat Toggle Switch
Foot Platform Angle Adjustment
You can adjust the angle of the foot platform with a hex key.
To adjust the foot platform angle:
1. Flip up the foot platform and locate the setscrew and jam nut.
See figure 23.
2. Loosen the jam nut.
3. Turn the setscrew to raise or lower the front of the foot plat-
form.
4. Tighten the jam nut to secure the setscrew.