Filter
Top Products
28 www.quantumrehab.com Quantum 610 Series
Figure 19. Underside of Armrest
SETSCREW
Figure 20. Mounting Block Controller Installation
MOUNTING
BLOCK
V. COMFORT ADJUSTMENTS
To change the armrest width:
1. Locate the two armrest knobs on each side of the arm-
rest receiver bracket. See figure 18.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the knobs.
Armrest Angle Adjustment
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to
the floor. See figure 18.
2. Loosen the jam nuts.
3. Turn the adjusting screw to raise or lower the front of the
armrest.
4. Tighten the jam nuts to lock the adjusting screw into place.
Controller Position
You can position the controller for either left-hand or right-
hand use.
MANDATORY! Do not place the controller
cable so that it can be pinched in the seat
frame or the power base frame.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the floor.
2. Loosen the setscrew on the controller bracket. See figure 19.
3. Slide the controller into or out of the armrest to the de-
sired position.
NOTE: If your power chair is equipped with a Specialty Seat, Synergy Seat, or TRU-Balance Power Position-
ing System, loosen the setscrews in the mounting block, slide the controller in or out to the desired position,
then tighten the setscrews. See figure 20.
To change the controller position:
1. Turn off the power to the controller.
2. Loosen the rear shroud fasteners and remove the rear shroud.
3. Unplug the controller connector from the power base.
4. Remove any wire ties securing the controller cable to the armrest.
5. Flip up the armrest so it is perpendicular to the floor.
6. Loosen the setscrew on the controller bracket
7. Slide the controller out of the armrest.
8. Loosen the setscrew in the other armrest.
9. Place the controller in the other armrest.
10. Tighten the setscrew to secure the controller.
11. Route the controller cable to the back of the power base and plug in the controller.
12. Replace the rear shroud and tighten the fasteners.
13. Secure the controller cable to the armrest with wire ties. See figure 13.
MOUNTING
SCREWS