Filter
Top Products
Power Tote P-100 Lift System www.pridemobility.com 9
III. INSTALLATION
NOTE: Ensure the hitch bolt is tightened firmly before
securing the nut to the hitch assembly to minimize the
chance that the lift will tilt during transport.
5. Route the lift system wiring harness through the vehicle.
Refer to “Wiring Harness Installation.”
WARNING! Prevent product damage!
Route the wiring harness through the
vehicle rather than under the vehicle to
avoid coming in contact with sharp edges,
extreme temperatures, moving parts, and
roadway debris. Power shorts may occur
if wires come in contact with hot exhaust
parts or sharp edges.
WARNING! Never attach the wiring
harness to a secondary power source. Do
not attempt to use trailer wiring to power
the lift system. The wiring harness must
be connected directly to the vehicle
battery.
6. Position the lift platform over the lift H-frame, aligning the
mounting holes in each. See figure 4.
7. Secure the lift platform to the H-frame with the supplied
hardware. See figure 4.
Wiring Harness Installation
The wiring harness is approximately 25 ft. (7.62 meters) long
and will accommodate most vehicles.
NOTE: You may wish to perform a practice run before
installing the wiring harness. Route a piece of light
rope (equivalent to the gage of the wiring harness)
along the anticipated path observing contact points,
potential rubbing/chafing points, and any sharp edges.
Remove sharp edges with a fine grade file, then treat
the steel with a rust inhibitor or metal sealant.
Figure 3. Lift Frame Vehicle Mounting (Class 3 Hitch
Tube Shown)
Figure 4. Lift Platform Installation
LIFT PLATFORM
H-FRAME
HITCH TUBE
HITCH
RECEIVER