Filter
Top Products
Power Tote P-100 Lift System www.pridemobility.com 11
IV. OPERATION
POWER TOTE P-100 LIFT SYSTEM OPERATION
The Power Tote P-100 Lift System is designed to lift an unoccupied wheelchair from the ground for the purpose of
easy vehicle transport.
WARNING! The Power Tote P-100 Lift System is intended for the transport of wheelchairs
only. The wheelchair must be unoccupied before operating the lift.
WARNING! Prevent vehicle damage! Do not exceed the load limits of your vehicle or hitch
system as specified by the vehicle manufacturer.
WARNING! Use extreme caution when driving with the lift installed on your vehicle. Be
aware that the lift extends away from the back of the vehicle and extra clearance is
needed when backing up, turning, parking, or driving through driveway entrances/exits.
Drive slowly when negotiating pot holes, road bumps, and railroad tracks.
Figure 6. Key Switch Operation
Follow these steps to operate the Power Tote P-100 Lift:
1. Insert the key into the key switch.
2. Turn and hold the key clockwise to lower the lift plat-
form. See figure 6. Release the key as soon as the lift
platform touches the ground.
3. Fold the wheelchair. Refer to the wheelchair owner’s
manual for more information.
4. Roll the wheelchair onto the center of the lift platform.
See figure 7.
NOTE: Make sure that the lock-down arm is in the fully
raised position before loading the wheelchair onto the
lift platform. See figure 7.
5. Engage the park brakes to lock the wheels in place. Refer
to the wheelchair owner’s manual for more information.
6. Turn and hold the key counterclockwise to raise the lift.
See figure 6. Continue to raise the lift until the motor stops,
then release the key.
NOTE: The motor will stop automatically at the top of
its stroke and will emit a clicking sound. Release the
key immediately upon hearing this sound.
Figure 7. Wheelchair Positioning
LOCK-DOWN ARM