Filter
Top Products
29
Maxima www.pridemobility.com
Figure 13. Seat Height Adjustment
SEATBACK ADJUSTMENT
The seatback may be positioned to four different
angles: 90°, 100°, 102° and 105°. See figure 12.
To adjust the seatback angle:
1. Loosen and remove the adjustment screws from
the seatback hinge on both sides of the seat.
2. Reposition the seatback to the desired angle.
3. Align the adjustment holes from the upper
and lower hinge, so the adjustment screw can
easily pass through.
4. Reinsert both adjustment screws and tighten.
90° ADJUSTMENT HOLE
100° ADJUSTMENT HOLE
102° ADJUSTMENT HOLE
105° ADJUSTMENT HOLE
Figure 12. Seatback Hinge
ADJUSTMENT SCREW
UPPER HINGE
LOWER HINGE
VIII. COMFORT ADJUSTMENTS
SEAT HEIGHT ADJUSTMENT
The seat can be repositioned to different heights.
See figure 13.
1. Remove the seat and rear shroud from your
scooter. See IX. “Disassembly and Assembly.”
2. Loosen the nut and remove it from the bolt, and
remove the bolt and washers from the lower
seat post.
3. Raise or lower the upper seat post to the
desired seat height.
4. While holding the upper seat post at that
height, match up the holes in the upper seat
post with those of the lower seat post.
5. Fully insert the bolt, reinstall the washers,
and tighten the nut.
Note: Ensure both washers have been rein-
stalled before fully tightening the nut.
6. Reinstall the rear shroud and the seat.
LOWER SEAT POST
UPPER SEAT POST
NUT
WASHER
BOLT
WASHER