Filter
Top Products
26 www.pridemobility.com Jazzy Select Series
Figure 14. Seatback/Armrest Adjustment
SEATBACK
ANGLE
ADJUSTMENT
SCREW
JAM NUT
ARMREST
HEIGHT
ADJUSTMENT
SETSCREWS
ARMREST
ANGLE
ADJUSTMENT
SCREW
Manual Recline Seatback Adjustment
If your power chair is equipped with a manual recline
seatback, you can adjust the seatback angle with the
seatback release lever. The lever is located on the right side
of the seat base. See figure 5.
To adjust the recline angle:
1. Pull up on the seatback release lever.
2. Lean forward or backwards to the desired position.
3. Release the lever.
Seatback Angle Adjustment
If your power chair is equipped with a limited-recline
seatback, you can adjust it to four (4) different angles: 90°,
102°, 105°, or 107°.
To adjust the seatback angle:
1. Remove the adjusting screws from each seat hinge. See
figure 14.
2. Set the seatback at the desired angle.
3. Reinstall the adjusting screws to each seat hinge and
tighten.
Armrest Width Adjustment
You can change each armrest’s width independently of
the other.
NOTE: Changing the armrest width may increase the
overall width of your power chair.
To change the armrest width:
1. Locate the two armrest knobs on each side of the
armrest receiver bracket. See figure 14.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the knobs.
Armrest Angle Adjustment
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to
the floor. See figure 14.
2. Loosen the jam nut.
3. Turn the adjusting screw to raise the front of the
armrest or to lower the front of the armrest.
4. Tighten the jam nut to lock the adjusting screw into
place.
V. COMFORT ADJUSTMENTS
ARMREST KNOB