Filter
Top Products
Jazzy 1170XL www.pridemobility.com 45
VIII. CARE AND MAINTENANCE
CARE AND MAINTENANCE
Your Jazzy 1170XL is a sophisticated power chair. Like any motorized vehicle, it requires routine maintenance
checks. You can perform some of these checks, but others require assistance from an authorized Pride
Provider. Preventive maintenance is very important. If you follow the maintenance checks in this section as
scheduled, you can help ensure that your power chair gives you years of trouble-free operation. If you have
any doubt as to your power chairs care or operation, contact your authorized Pride Provider.
Your power chair, like most electrical equipment, is susceptible to damage from the elements. Avoid damp
areas of any kind.
WARNING! Direct exposure to water or dampness could cause the power chair to
malfunction electronically and mechanically. Water can cause electrical components to
corrode and the chairs frame to rust.
Should your power chair come in contact with water:
1. Dry your power chair as thoroughly as possible with a dry towel.
2. Allow your power chair to sit in a warm, dry place for 12 hours to allow unseen water to evaporate.
3. Check the joystick operation and the brakes before using your power chair again.
4. If any inconsistencies are found, take your power chair to an authorized Pride Provider.
Temperature
Some of the parts of your power chair are susceptible to extreme changes in temperature. Always keep your
power chair between the temperatures of 18° F and 122° F.
n In extremely cold temperatures the batteries may freeze. The specific temperature at which they freeze
depends on a number of factors, such as battery charge, usage, and composition of the batteries (e.g.,
AGM or Gel-Cell).
n Temperatures above 122° F may cause your power chair to operate at a reduced speed. This reduced
speed is a safety feature built into the controller that helps prevent damage to the motor and other
electrical components. See VII. Operation.
General Guidelines
n Avoid knocking or bumping the controller, especially the joystick.
n Avoid prolonged exposure of your power chair to extreme conditions, such as heat, cold, or moisture.
n Keep the controller clean.
n Check all connectors on the electronics tray to ensure that they are all tight and secured properly.
n Make sure the drive tires are inflated to 35 psi.
WARNING! Make sure your tires are inflated to 35 psi. Do not underinflate or overinflate
your tires. Low pressure may result in loss of control, and overinflated tires may burst.
Overinflating tires can cause them to explode and can result in personal injury.
WARNING! Do not use a high pressure hose to inflate your tires.