Filter
Top Products
36 www.pridemobility.com Victory Sport
VII. DISASSEMBLY AND ASSEMBLY
Frame Separation
1. Arrange the front wheel(s) in a straight
forward-facing position.
2. Lower the tiller and tighten the tiller
adjustment knob.
NOTE: The pivoting tiller is equipped with a
mechanism that will lock the front wheels in
place when the tiller is completely lowered and
secured.
3. Grasp and lift up on the frame release lever.
See figure 23.
4. Lift the front section up until the frame hooks
of the front section separate from the rear
section. See figure 24.
5. Slowly separate the two sections.
See figure 24
.
ASSEMBLY
1. Position the front and rear sections of your
scooter as shown in figure 24.
2. Use the frame release lever to lift the front
section as you align the frame hooks of the
front section with the lower frame tube of the
rear section. See figure 24.
3. Once the frame hooks are over the lower
frame tube, lower the front section
completely. This will engage the frame lock.
4. Raise the tiller and fully tighten the tiller
adjustment knob.
5. Reinstall the batteries to the battery wells.
6. Connect both battery harnesses.
See figure 22
.
7. Secure the battery tie-down strap.
8. Reconnect the front-to-rear harnesses.
9. Reinstall the battery shroud.
10. Reinstall the seat and rotate it into place.
WARNING! After assembly, make
absolutely certain the tiller lock
knob is in the unlocked position
before driving the scooter.
Figure 23. Frame Release Lever
FRAME
RELEASE
LEVER
Figure 24. Frame Separation
FRAME HOOKS
LOWER FRAME TUBE