Filter
Top Products
Basic Operation Instructions 13
www.pridemobility.com GC Controller
THERMAL ROLLBACK
The GC Controller is equipped with a thermal rollback circuit which monitors the
temperature of the chair’s motors and controller. If either exceeds the safe operating
temperature, the controller reduces the output to 50% of full operation level. This
reduces the chair’s speed and allows a cool down period. Once the temperature
returns to a safe level, the chair will resume normal operation.
FAULT CODES
The battery condition meter will flash fault codes when the controller system detects
an abnormal condition in the electrical system. All of the battery condition meter
LEDs will flash a number of times quickly, then pause, then flash again. The battery
condition meter will continue to flash the fault codes until the problem is fixed. The
table below identifies the individual fault codes. If any of these fault codes persist,
contact your authorized Pride Provider.
2. Release the on/off key.
3. Move the joystick to the full forward position until it beeps.
4. Move the joystick to the full rearward position until it beeps.
5. Release the joystick. There will be one long beep. The controller system is
now locked.
NOTE: The maximum speed indicator/battery condition meter will be rip-
pling from side to side. The sequence will continue until the power is
turned off or until the controller is unlocked.
To unlock the controller:
1. Press the on/off key to turn on the controller. The maximum speed indicator/
battery condition meter will ripple the “locked” sequence.
2. Move the joystick to the full forward position until it beeps.
3. Move the joystick to the full rearward position until it beeps.
4. Release the joystick. There will be one long beep. The controller system is
now unlocked.