Filter
Top Products
22 www.pridemobility.com Quantum Jazzy 1420 Series
IV. ASSEMBLY
To install the seat:
1. Set the trapeze bars to the desired height. To change the
trapeze bar height, see V. “Comfort Adjustments.”
2. Tilt the seat back and slide the rear extrusion onto the
rear trapeze bar. See figure 10.
3. Lower the front extrusion onto the front trapeze bar
until the seat locks into place.
4. Flip the seat latch safety down.
WARNING! Make sure the seat latch safety
is flipped down before using your power
chair.
Power Elevating Seat Installation (Optional)
Your power chair may be equipped with the power
elevating seat option. While the seat itself may be any one
of the styles offered for this model, the way the seat base
attaches to the power base is different.
To install the power seat:
l. Align the seat shaft to the hole in the actuator. See
figure 11.
2. Insert the seat shaft into the actuator and push the seat
lever forward.
3. Lock the seat into place.
4. Plug the power elevating seat switch cable into the
connector on the electronics tray.
Controller Installation
Depending on the various configurations and options you
have chosen for your power chair, it may have been shipped
without the controller module installed in the armrest.
WARNING! Do not place the controller
harness so that it can be pinched in the
seat frame or power base frame.
1. Flip up either the right or left armrest.
2. On a contour seat, flip up the armrest and loosen the
setscrew. See figure 12.
3. Slide the controller into the armrest.
4. Tighten the setscrew(s) and lower the armrest.
5. Route the controller harness so that it cannot be pinched
in the seat hinge.
MANDATORY! Prevent controller harness
damage! Avoid routing the controller harness
on the outside of the armrest pad. Route the
harness under the armrest or toward the
inside of the armrest pad. Use correct tie-
down points for the controller harness to pre-
vent the harness from getting caught in the
drive tires, pinched in the seat frame, or dam-
aged when passing through doorways.
6. Remove the rear lid to expose the electronics tray.
7. Plug the controller connector into the electronics tray.
See figure 7.
8. Secure the controller harness to the armrest receiver
with one or more wire ties. See figure 13.
Figure 12. Controller Installation (Underside of
Armrest)
SETSCREW
CONTROLLER BRACKET
Figure 13. Controller Harness Routing on a Contour
Seat
Figure 11. Power Elevating Seat Actuator