Filter
Top Products
Quantum 614 Series www.pridemobility.com 27
FOOT
PLATFORM
BRACKET
V. COMFORT ADJUSTMENTS
Controller Position
You can move the controller in toward or out away from
the armrest, or change the position of the controller for
either left-hand or right-hand use.
WARNING! Do not place the controller
harness so that it can be pinched in the
seat frame or the power base frame.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the floor.
2. Loosen the setscrew on the controller bracket. See
figure 17.
3. Slide the controller into or out of the armrest to the
desired position.
4. Tighten the setscrew to secure the controller.
To change the controller position:
1. Turn off the power to the controller.
2. Unplug the controller connector(s) from the power
base.
3. Cut the wire tie(s) securing the controller harness to
the armrest.
4. Flip up the armrest and loosen the setscrew. See fig-
ure 17.
5. Slide the controller out of the armrest.
6. Loosen the setscrew in the other armrest.
7. Place the controller in the other armrest.
8. Tighten the setscrew in each armrest.
9. Use a wire tie to secure the controller harness to the
armrest.
10. Plug the controller connector(s) into the power base.
NOTE: If your power chair is equipped with a Synergy
Seat or TRU-Balance Power Positioning System, refer
to the controller adjustment information contained in
separate manuals.
Foot Platform Height Adjustment
The foot platform height is easily adjusted to several dif-
ferent heights.
To raise or lower the foot platform:
1. Remove the hardware from the foot platform bracket.
See figure 18.
2. Loosen the foot platform securement nut one-half
turn.
3. Raise or lower the foot platform to the desired height.
4. Reinstall the hardware into the foot platform bracket
and tighten.
5. Tighten the securement nut.
Figure 17. Underside of Armrest
Figure 18. Foot Platform Adjustment
SECUREMENT NUT
SETSCREW
CONTROLLER
BRACKET