Filter
Top Products
36 www.pridemobility.com Jazzy 610 Series
VII. CARE AND MAINTENANCE
Figure 21. Jazzy 610 Drive Wheel
TYRE
DRIVE WHEEL NUT
DRIVE WHEEL WASHER
Figure 22. Jazzy 610 Drive Wheel Disassembled
TUBE
FRONT RIM HALF
REAR RIM HALF
NUTS
WASHERS
AXLE KEY
WHEEL HUB
AXLE SLOT
4. Remove the drive wheel nut and washer from the axle. See figure 21.
5. Pull the wheel off the axle.
6. Remove the nuts and washers from the wheel hub and separate the front and rear rim. See figure 22.
7. Remove the old tube from the pneumatic tyre and replace it with a new tube or replace the entire assembly if it is a
solid tyre.
8. Reassemble the rims and reinstall the nuts and washers to the wheel hub.
9. Slide the wheel back onto the axle. Make sure that the key is in the axle slot.
10. Reinstall the drive wheel nut and washer onto the wheel axle and tighten.
11. Inflate the pneumatic tyre to 2.4 bar (35 psi).
12. Remove the power chair from the blocks.
Battery Replacement
A battery wiring diagram is printed on a decal located on the front battery tray. See VI. “Batteries and Charging” for
correct battery specifications.
WARNING! Battery posts, terminals and related accessories contain lead and lead
compounds. Wear goggles and gloves when handling batteries and wash hands after
handling.
WARNING! Do not replace battery when seat is occupied.
WARNING! The batteries on your power chair should only be serviced or replaced by
an authorised Pride Dealer or a qualified technician.
WARNING! Power chair batteries are heavy. See specifications table. If you are unable
to lift that much weight, be sure to get help.
WARNING! Do not mix or match new and old batteries. If you encounter a situation
where one battery needs to be replaced, then replace both batteries. Refer to the
specifications table in this manual and the manual supplied with the battery charger
for recommended type and capacities.
WARNING! COMPLETELY DEFLATE THE
TYRE BEFORE ATTEMPTING REPAIR.