Filter
Top Products
Jazzy Elite Series www.pridemobility.com 13
COMFORT ADJUSTMENTS
After becoming familiar with your power chair’s operation, you may find the need to make some adjustments to
increase your comfort, such as seat height, armrest angle, foot platform angle, depth, and height, and controller
position. Refer to the following information before making comfort adjustments.
WARNING! The center of gravity of your power chair was factory set to a position that meets the
needs of the demographic majority of users. Your authorized Pride Provider has evaluated your
power chair and made any necessary adjustments to suit your specific requirements. Do not
change your seating configuration without first contacting Pride Mobility Products or your
authorized Pride Provider.
WARNING! Some power chair components are heavy. You may need assistance to lift or carry
them. Please refer to the product specifications for specific component weights before you
disassemble the power chair.
WARNING! Remove the occupant from the power chair before making any adjustments.
V. COMFORT ADJUSTMENTS
Figure 8. Seat Height Adjustment
You may need the following to make comfort
adjustments:
metric/standard socket set and ratchet
adjustable wrench
metric/standard hex key set
thread lock
Seat Height Adjustment
You can change the seat height to one of three posi-
tions in 1-in. (2.54-cm) increments. If you raise or
lower only one trapeze bar (front or rear), you can
also change the seat base angle (dump).
To change the seat height:
1. Turn off the power to the controller.
2. Make sure the power chair is in drive mode.
3. Unplug the controller connector(s) from the
power base. See figure 3.
4. Flip up the seat latch safety. See figure 6.
5. Squeeze the seat latch and release the seat from
the front trapeze bar.
6.
Slide the seat forward and remove it from the power
base.
7. Remove the hardware that attaches the trapeze
bars to the seat interface weldments. See figures
6 and 8.
8. Move the trapeze bars up or down to the desired
height.
NOTE: Change the seat dump by raising or lower-
ing only one trapeze bar (front or rear).
9. Reinstall the hardware.
10. Reinstall the seat.
11. Reconnect the controller to the power base.
SEAT
CONTROLLER
CONNECTOR
HARDWARE
SEAT
INTERFACE
WELDMENT