Filter
Top Products
30 www.pridemobility.com Jazzy 1103 Ultra
Power Elevating Seat Operation
If your power chair is equipped with a power elevating seat, you can change the seat height either through the controller or
through a toggle switch mounted to one of the armrests. See figure 26.
NOTE: For information on how to raise and lower your seat through the controller, contact your authorized
Pride Provider.
To operate the power elevating seat:
1. Bring your power chair to a complete stop.
2. Push the toggle switch forward to raise the seat or pull the switch rearward to lower the seat. When you release the
switch, the seat will stop.
The power elevating seat system has an upper and a lower limit of travel. Once the actuator reaches either one of these
limits, you should continue to hear and/or feel the actuator motor running. This is because there is a clutch mechanism that
allows the motor to continue running after the actuator has reached its limit. This clutch works at both the top and bottom
extensions of the lift.
WARNING! Do not allow the motor to run more than a few seconds after the mechanism reaches
the top or bottom limit. This can damage the motor.
The power elevating seat is equipped with a swivel feature that allows the seat to be turned 90 degrees to whichever side
the controller is located.
To use the swivel feature:
1. Locate the friction lock lever under the seat. See figure 11.
2. Pull back the friction lock lever to rotate the seat in 90° increments.
3. Pull the friction lock lever forward to lock the seat in place.
V. COMFORT ADJUSTMENTS
TOGGLE
SWITCH
Figure 26. Power Seat Toggle Switch
WARNING! Prevent personal injury! Do not attempt to drive the power chair with the seat facing to
the side. Always return the seat to the forward facing position before operating the power chair.