Filter
Top Products
Page 12
Installation Instructions
N900
series install
3. Assemble the
weighing platform
Place the cover on the weighing
platform. Press down on each corner
to be sure it is completely seated.
4. Remove the control
module cover
Remove the cover from the top rear
of the control module and set aside.
5. Install the Rate PROM
Slide the Rate PROM into the slot with
the unlabelled side facing you. Press
it firmly until it snaps into place. Refit
cover.
6. Connect weighing
platform to control
module
Turn the control module over and plug
the small end of the weighing platform
cable into the back of the module.
Underside of
Control Module