Filter
Top Products
When you use the appliance for the rst time, we advise you to try it
out on an area with only light hair growth. This helps you get
accustomed to the epilation process.
For optimal epilation results, the hairs should not be longer than
10mm. Use one of the following methods if the hairs are longer than
10mm:
1 Shorten the hairs to a maximum length of 10mm with a trimmer.
Afterwards you can immediately start with epilation.
2 Shave the hairs completely. Then you can start to epilate after a few
days (minimum hair length 0.5mm necessary).
Your skin may become a little red and irritated the rst few times you
use the epilator. This phenomenon is absolutely normal and quickly
disappears. As you use the appliance more often, your skin gets used
to epilation, skin irritation decreases and regrowth becomes thinner
and softer. If the irritation has not disappeared within three days, we
advise you to consult a doctor.
We advise you to epilate before you go to bed at night, as this allows
any skin irritation that may develop to diminish overnight.
Epilating with the cooling glove
Make sure your skin is clean, entirely dry and free from grease. Do not
use any cream before you start to epilate.
1 Insert the appliance plug into the bottom of the appliance and put
the adapter in the wall socket.
2 Put the ice gel pad in the compartment of the cooling glove with
the transparent cover (Fig. 6).
Only use the ice gel pad in combination with the cooling glove.
3 Push your hand into the cooling glove and start cooling the area
you want to epilate (Fig. 7).
Do not leave the cooling glove on the same area for more than 2
minutes.
4 Select the desired speed to switch on the appliance (Fig. 8).
Select speed 1 for areas with little hair growth and for areas where
bones are located directly beneath the skin, such as knees and ankles.
-
-
-
-
-
ENGLISH 9