Filter
Top Products
Troubleshooting
The red light. starts blinking but the motor does not start running when
the on/off button is pressed.
1 If the battery is completely empty, the red battery-low light. starts
blinking but the motor will not start running when you try to
switch the trimmer on. Charge the appliance until it is fully
charged (see chapter 'Charging').
If the suction system of the vacuum beard trimmer performs poorly or
does not work at all, check the points listed below.
2 Is the hair-collection chamber empty?
B
We advise you to empty the hair-collection chamber after each
trimming session.When cutting long, dense beards, it may also be
necessary to empty the hair-collection chamber during the trimming
session.
3 Is the hair-collection chamber or the filter wet?
B
Both parts may only be cleaned dry. If these parts become wet, dry
them carefully.
4 Does the flexible hair guide in front of the cutting unit jam?
B
The transparent hair guide needs to be flexible in order to be able to
adjust to the contours of the face. If it jams because hairs have got
stuck in it, remove the hairs carefully with the brush supplied.The
flexible hair guide should yield at the touch of a finger.
5 Do you move the appliance in the optimal direction? (fig. 8).
B
For the best possible trimming and suction performance, we advise you
to move the trimmer upwards, against the direction of hair growth,
making smooth and gentle strokes.
ENGLISH 13