Filter
Top Products
3 Set your iPod/iPhone to pause position or switch it off.
When you have selected your iPod/iPhone as alarm sound, the paused song starts playing at ,
the set alarm time.
Note: If the iPod/iPhone is unable to play the selected song, you hear the bird alarm sound of the Wake-
up Light at the set alarm time.
Snoozing
1 Gently push down the control lever to the bottom position when the alarm goes off (Fig. 21).
The light continues to be on at the selected intensity level, but the alarm sound stops. After 9 ,
minutes, the wake-up sound is automatically played again.
Note: The 9-minute snooze time is xed. This time cannot be adjusted.
Note: If you push down the control lever with too much force, it may jump back to off position.
Alarm demonstration
If you want to get a quick demonstration (60 seconds) of the gradually increasing light level and
sound level, activate the test function of the appliance.
1 Push the control lever down to the bottom position for a few seconds until TEST appears on
the display (Fig. 22).
2 Push the control lever down again to stop the demonstration.
Note: The appliance continues to run the alarm demonstration until you push down the control lever
again. The test automatically stops after 9 hours.
Using the lamp
You can use the top dial to switch on the lamp as a bedside lamp and to set the light intensity.
1 To switch on the lamp, press the top dial gently and release it (Fig. 23).
Note: It takes approx. 1 second for the lamp to go on. This is normal, the lamp needs to heat up.
Note: The lamp does not go on when you press the top dial while the appliance is in the menu.
2 Move the top dial up or down to select the light intensity level you prefer (Fig. 24).
You can choose a light intensity between 1 and 20.
Note: The light intensity you have selected is automatically set as the light intensity level for the alarm as
well.
3 To switch off the lamp, press the top dial gently and release it.
Note: You can also move the top dial up or down to check and/or select a light intensity level without
pressing the top dial rst.
Radio/volume
1 To switch on the radio, press the bottom dial gently and release it (Fig. 25).
2 To select the desired radio frequency manually, move the middle dial up or down (Fig. 26).
Tip: To scan radio frequencies automatically, press and hold the middle dial for approx. 2 seconds.
Tip: To make sure you get a good radio signal, fully unwind the antenna and move it around until you
have found a position at which reception is best.
3 To switch off the radio, press the bottom dial gently and release it.
ENGLISH 13
09_HF3490_Oct.indd 13 10/15/09 12:54:05 PM