Philips 8867XL Electric Shaver User Manual


 
LED Battery Charge Meter
The Meter provides the following information:
C
LED Battery Charge Meter
The number (percentage) on the display indicates
approximately how much power is left in the
batteries.
C
Low Battery Indicator
If the batteries run low, the “20” Light on the
display lights up red.When you turn the razor
OFF,the “20”light will blink for approximately 4
seconds.
C
Charging Indicator
When you charge razor, the “20” Light on the
display turns red.After approximately 3 minutes, it
will then turn green and blink.As charging
continues, more and more lights of the display
meter will light up green to indicate what level
(percentage) of the batteries have been charged.
C
Full Charge Indicator
When the batteries have been fully charged, all
the lights on the display will light up green.
Charging
Battery performance is best if you recharge
only when batteries are (almost) completely
empty.
Charging or recharging at temperatures
below 40ºF or higher than 95ºF adversely
ENGLISH10
affects lifetime of batteries.
Continuously recharging or continuously using
as a corded razor will reduce life of batteries.
You may also shave using the charging plug
provided.This razor will not recharge while
being used corded.
The charging plug transforms 100-240 volts to
a voltage lower than 24 volts.
Do not charge razor in pouch.
Recharge only when the “20” lights up red.
C
1 Connect cord to razor. Connect charging
plug into any 100V to 240V AC outlet. Use
only the charging plug provided.
As you charge razor, the “20” Light on the display
turns red.After approximately 3 minutes, it will
then turn green and blink. As charging continues,
more and more lights of the display meter will
briefly blink green and light up to indicate what
level (percentage) of the batteries have been
charged.
An adaptor plug may be necessary for
charging plug usage in some foreign countries.
Use an attachment plug adaptor of the proper
configuration for the power outlet.
Your new razor will automatically convert to
work on 100V to 240V AC Systems.
2 First time charging and recharging after
non-use for 1 month or more requires a
full 4 hours.
When batteries are fully charged, all the “lights” in
the display will light up green.
ENGLISH 11