Filter
Top Products
8.
7 Slide and remove one cutter and head at a time to clean.
• Be careful not to mix up cutters and heads.They
are a matched set and if interchanged, it will greatly
affect shaving performance.
8 Separate the cutter from the head.
9 Only brush the cutter in an upward motion.
Use the short bristled side of the brush.
10 Brush the slots of the razor head.
For optimum performance, razor cutters and heads
should be cleaned in a degreasing liquid (e.g. Norelco
Razor Cleaner or alcohol) and lubricated with Norelco
Razor Lubricant, model AL80, or one drop of mineral oil
(in the center of the head).
11 Replace the cutter into head section. Slide razor head
back into frame making sure that flat rim of cutting
heads slides under 2 clamps on frame.
12 Repeat the process for the other two razor heads
(cutters and heads).
13 Replace the frame.
9.
14 Press down and turn the wheel clockwise until it locks
into place.
15 Replace the Razor Head Assembly back on razor.
After Each Use:Trimmer
1 Turn razor OFF.
2 Push Trimmer Slide Switch up to pop-up Trimmer.
3 Clean Trimmer with the brush every time you use it.
4 Lubricate the Trimmer teeth with Norelco Razor
Lubricant (model AL80), or with one drop of mineral
oil every 6 months.
5 Close Trimmer by sliding Trimmer switch down.