Filter
Top Products
7
Turn the shaver on and pour some
water over the outer foil.
After about 10-20 seconds, turn the
shaver off.
Remove the foil frame and clean it
with running water.
Wipe off any moisture from the
shaver with a dry cloth and remove
the protective cap to allow the sys-
tem outer foil to dry completely.
Brush cleaning
Squeeze the system outer foil re-
lease buttons and lift the system
outer foils upward to remove them
(see fig. 7). Remove the inner blades
by grasping them firmly at both ends
and pulling them straight away from
the shaver (see fig. 8). Clean the
outer foils, the shaver body and the
trimmer with the long side of the
brush. Clean the inner blades with
the short side of the brush. Do not
use the short brush to clean the outer
foils (see fig. 9).
Replacing shaving head
components
It is recommended that you replace
the outer foil at least every year and
the inner blades at least every two
years to maintain your shaver’s cut-
ting performance.
Replacing the system outer foil
(see fig. 7)
Squeeze the system outer foil re-
lease buttons and lift the system
outer foil upward to remove it. To in-
sert the new system outer foil, press
down until it snaps into place.
Replacing the inner blades
(see fig. 8)
Squeeze the foil frame release but-
tons and lift the foil frame upward to
remove it. Remove the inner blades,
one at a time, by grasping them firmly
at both ends and pulling straight
away from the shaver. To insert the
new inner blades, hold the blades,
one at a time, at both ends and press
downward until they snap into place.
For environmental protec-
tion and recycling of
materials
This shaver contains Nickel-Metal
Hydride battery(s).
Please make sure that the battery(s)
are disposed of at an officially as-
signed location, if there is one in your
country.
How to remove the built-in
rechargeable battery(s) before
disposal of the shaver
(see fig. 10)
The battery(s) in this shaver is not
intended to be replaced by consum-
ers. However, the battery(s) may be
replaced at an authorized service
center. The procedure described be-
low is intended only for removal of
the rechargeable battery(s) for the
purpose of proper disposal.
1. Remove the cap, outer foil frame
and inner blades.
2. Remove the two screws (b) and
driving bars (a).
3. Remove two screws (c) and bot-
tom cover (d).
OS01G108_ES7016_EUR_en 1/28/02, 9:29 AM7