Filter
Top Products
11
Safety precautions
• Use only the included Adaptor.
• Please use the appliance at a
temperature of between 0~40°C.
• Always ensure the appliance is
operated on an electric power
source matched to its rated
voltage.
• Never operate the appliance if the
cord or adaptor are damaged or
overly hot, or if the plug fits
loosely in the power outlet.
• Keep the device away from
sources of heat or flame.
• Do not allow the appliance to be
used by, on, or near children.
• Do not allow the appliance to be
used or left in the vicinity of sinks,
bathrooms, or other high-humidity
areas, where it could be exposed
to water and moisture.
• Do not allow the appliance to be
immersed in, splashed with, or
rinsed under water.
• Do not modify the cord or damage
it in any way such as by bending,
twisting or pulling on it
unnecessarily.
• Do not wrap the output cord tightly
around the appliance.
• Regularly clean the cord
connector, which plugs into the
appliance, to keep it free of dust
and foreign objects such as pins,
etc.
• Replace the shaving foil and the
inner blade when you notice a
reduced shaving performance.
• A damaged or defective appliance
should be returned to the
customer service center or to an
authorized customer service
agent.
• Do not attempt to use a defective
appliance or repair the appliance
yourself. Disassembly and repair
should only be carried out by a
qualified technician.
• The AC adaptor can be positioned
in a vertical or horizontal position.
10
with the fingers, use the fingernail
to release the plastic panel
Fb
on
the blade from the catches
Fa
on
the inside of the frame.
Fitting the new outer foil
Holding the outer foil so that the
surface with the plastic panel
F
b
(i.e.
the surface that will contact the
inner blade) faces upward, insert
into the frame so that the catches
Fa
on the frame fit into the holes on
the foil.
For environmental protection
and recycling of materials
(ES2029 only)
This epilator contains Ni-MH batteries.
How to remove the built-in
rechargeable batteries
before disposal of the
epilator (Fig. 6 - ES2029 only)
The batteries in this epilator are not
intended to be replaced by
consumers. However, the batteries
may be replaced at an authorized
service center. The procedure
described below is intended only for
removal of the rechargeable batteries
for the purpose of proper disposal.
• Always unplug the power cord
from the epilator before disassem-
bling it.
• Always slide the switch to 1 or 2
until the batteries are completely
discharged.
• Using a screwdriver, disassemble
the unit in the following order.
1. Remove the head while pushing
on the head release button.
2. Remove screws
F
a
.
3. Remove cover
Fb
and cover
Fc
while pushing on the head
release button and then remove
cover
Fd
.
4. Use a screwdriver to remove
the Ni-MH batteries.
(Please take care not to allow
the batteries to short out on
anything.)
ATTENTION:
2 nickel metal hydride batteries
that are recyclable power the
product you have purchased.
Please call 1-800-8-BATTERY
for information on how to recycle
the batteries.