Filter
Top Products
5
About the LED display
While charging
After charging is
completed
10 minutes after
charging is completed
HIGH
MID
LOW
HIGH
MID
LOW
HIGH
MID
LOW
glows.
“HIGH”, “MID” or
“LOW” blinks.
•
blinks once every
second.
blinks once every 2
seconds.
“HIGH/MID/LOW” go
out.
•
While using
HIGH
MID
LOW
“HIGH” blinks ‑ The battery capacity is enough.
“MID” blinks ‑ The battery capacity is approx.
60% or less.
“LOW” blinks ‑ The battery capacity is approx.
10% or less.
Charge the clipper when “LOW” starts to blink.•
Charging without the charging stand
1. Slide the po
wer switch to “0·CHARGE”.
2. Plug in the AC adaptor into a household outlet.
3. Insert the appliance plug into the clipper.
AC operation
If you connect the AC adaptor to the clipper in the same way as for charging,
and turn on the power, you can use it even if the battery capacity is low.
If the clipper does not operate, charge the clipper for approximately
1 minute.
Be careful not to discharge the battery completely with the power left turned
on. It results in shortening the battery life.
•
•