Filter
Top Products
6
GB
HOW TO CHECK REMOTE AND INDOOR
TEMPERATURES
The indoor temperature is shown on the second line of the display.
The outdoor temperature is shown on the top line of the display.
The kinetic wave display on the outdoor temperature indicates if
the reception of the remote unit is in good order.
If no readings are received from the remote unit for more than four
minutes, blanks “ ” will be displayed until further readings are
successfully searched. Check if the remote unit is sound and secure.
You can wait for a little while or press [ ] and [ ] simultaneously
to enforce an immediate search.
If the temperature goes above or below than the temperature
measuring range of the main unit or the remote unit (stated in
specification), the display will show “HHH” or “LLL”.
HOW TO READ THE KINETIC WAVE
DISPLAY
The kinetic wave display shows the signal receiving status of the
main unit. There are three possible forms:
THE RESET BUTTON
This button is only used when the unit is operating in an unfavorable
way or malfunctioning. Use a blunt stylus to hold down the button.
All settings will return to their default values.
GETTING STARTED
Once batteries are in place for the remote unit, they will start
transmitting temperature readings at 78-second intervals.
The main unit will also start searching for signals for about four
minutes once batteries are installed. Upon successful reception, the
outdoor temperature will be displayed on the top line and the indoor
temperature on the second line. The main unit will automatically
update its readings at about 78-second intervals.
If no signals are received, blanks " " will be displayed and the
kinetic wave icon will show “ “. Press [ ] and [ ]
simultaneously to enforce another search for about 4 minutes. This
is useful in synchronizing the transmission and reception of the
remote and main units.