Filter
Top Products
9
EN
RECALLING MEASUREMENTS STORED IN
THE MEMORY
The memory can hold up to 8 records. The records are
automatically stored each time you take a new measurement.
Note:
· The most recent record (1) is shown first. Each new
measurement is assigned to the first (1) record. All other
records are pushed back one digit (e.g., 2 becomes 3,
and so on), and the last record (8) is dropped from the
list.
· Press MEM / UP again to see additional records.
· The date and time of measurement are shown with each
record.
· Memory records will be kept even when the batteries
are replaced.
TROUBLESHOOTING GUIDE
This section includes a list of error messages and frequently
asked questions for problems you may encounter with your
blood pressure monitor. If the product is not operating as
you think it should, check here before arranging for servicing.
Lying down
3. Relax your hand.
4. Press the ON button.
Result: After a few seconds, the blood pressure monitor
beeps and begins inflating the wrist cuff. It then slowly
deflates until there is another beep, signifying that the
measurement is complete. Don’t move from the first beep
until the last to ensure a more accurate measurement.
Your systolic and diastolic pressure readings flash on the
display, followed by MAP (Mean Arterial Pressure, see
page 4) and pulse per minute readings every two
seconds. The measurement is automatically stored as
the first (1) entry in the memory; the last entry (8) is
dropped, and all the entries in between move up one
digit (e.g., 7 becomes 8, and so on).
Position your wrist on a support, cushion,
or your thigh so that it is parallel with your
heart with the palm facing up.