Filter
Top Products
24 25
5. Place the stethoscope on the
patient's arm.
6. Push the START Button to start the
measurement.
• Do not push the START Button without
wrapping the cuff.
• Do not squeeze or press the cuff during
the measurement.
• If you want to inflate again after the start
of deflation, push the START Button.
• If you want to accelerate deflation after the
start of deflation, push the DEFLATION
(deflation control) / Measurement Results
Display Switch Button. Each time the
Button is pushed, cuff is deflated rapidly in
increments of 5 to 10 mmHg.
9. Push the ON/OFF (power) Button to
turn off the power.
7. Take the readings.
8. Push the STOP Button to remove air
inside the cuff.
• The unit does not automatically deflate in
the MANU Mode.
If the monitor determines that the pressure
value is not correct, an error display appears
(Er1 to 9). In this case, refer to Page 28 and
start the measurement again.
1. Push the ON/OFF (power) Button to
turn on the power.
3. Set the P-SET (inflation level setting)
Knob to "AUTO" or the target
pressure value.
4. Measure the patient’s arm size and
wrap appropriate cuff over the
patient's arm. (Refer to pages 14
and 15.)
2. Set the MODE Selector to "MANU".
HOW TO MEASURE
BLOOD PRESSURE
(IN MANUAL MODE)
HOW TO MEASURE
BLOOD PRESSURE
(IN MANUAL MODE)
HEM-907 10/23/03 3:13 PM Page 24