Filter
Top Products
10 11
English
Aerosol output is adjustable by rotating the delivery rate
adjust knob placed on the cover.
Rotate the knob counterclockwise to increase the rate, or
clockwise to reduce the rate. Adjust it to your requirements.
Sit relaxed at a table and breathe in the aerosol delivered
through the mouthpiece or air tube (optional part).
➂ Assembling
Mount the medication cup holder and the cover onto the main
unit.
Couple the main unit with the AC adaptor. (Fit them by pressing
until it clicks).
Connect the plug to a wall-plug (AC 220V – 230V~).
Caution:
Before plugging the unit in, make sure that the voltage rating
on the back of the AC Adaptor and the supply voltage value
match.
Press the -button for intermittent operation. The
nebuliser will not operate if it is not pressed.
Press the OFF/ON ( )-button for continuous operation. The
nebuliser will operate continuously until it is pressed again,
which stops the unit.
Notes:
1. During operation a green power light will illuminate. This
light must be lit for the unit to operate.
2. The unit is equipped with a heat sensor. If, during operation,
excessive heat occurs, the unit will automatically shutoff.
The unit will operate properly when normal operating tem-
perature is reached. Store the unit in a well ventilated loca-
tion (near an open window for example). Please wait at least
30 minutes before restarting inhalation.
Start the
treatment
Press the continuous operation button ( ) after use.
(Nebuliser lamp goes out).
End of
operation
➀ Remove the plug from the mains socket.
(Do not pull the power cord. Be sure to pull it out by
holding the power plug).
➁, ➂ Lift the casing up, while pressing the front and rear
unlock buttons of the AC adaptor. Remove the main
unit.
➃, ➄ Remove the cover and the medication cup holder from
the main unit.
Cleaning
NE-U07
NE-U07