Filter
Top Products
8
2.Preparation
2.2 Setting the Date and Time
Your blood pressure monitor automatically stores up to 90
measurements values in its memory and calculates an average
reading based on the measurements from the last three
readings taken within 10 minutes.
• Set the monitor to the correct date and time before taking a
measurement for the first time.
• If the batteries have been removed for 30 seconds or more,
the date and time setting will need to be reset.
1. When the batteries are installed, the
year digits will flash in the display
when you turn on the monitor.
Note: If you need to reset the date
and time for some reason,
hold down the button while the power is off.
2. Press the button to advance
the digits one at a time.
To change the digits to a lower
number, press the button to
lower the digits one at a time.
If you hold down the or
button, the digits will advance (or lower) rapidly.
3. Press the button to confirm the
setting when the desired number
appears on the display.
HEM-7000 main.book Page 8 Monday, June 19, 2006 8:53 AM